Products

High Masts

High Mast

MAST STRUCTUR :Our high mast is a continuously tapered, polygonal cross section of at least 20 sides, presenting a good and pleasing appearance which is based on proven in tension design conforming to the Technical report.

MODEL NO : SHM-12-40MTR


CONSTRUCTION:

High mast is fabricated from steel plates Conforming IS Standard, cut and folded to from a polygonal section. Masts are in two sections for 12 - 20 Mtr. and in three sections for 20 & 30 MTr. heights having only longitudinal weld conforming to BS 5135/AWS. The mast is provided with a fully penetrated flange which is free from any laminations or incursions. The welded connection of the base flange is fully developed to the strength of the entire section. The base flange is provided with supplementary gussets between bolt holes to ensure elimination of helical stress concentration. For environmental protection of the mast, the entire fabricated mast is Hot Dip Galvanized (86 Microns) internally and externally, having uniform coating

HEIGHT OF HIGH MAST

12-40MTR

NO OF MAST SECTION

1-4 POLYGONAL TYPE

TYPE OF MAST

FIXED POLYGONAL TELESCOPIC JOINT TYPE

TYPE OF MAST PAINTING

GALVANIZED

NO OF WINCH

1

TYPE OF WINCH

MANUAL CUM MOTOR OPERATE

NO OF LIGHT FITTINGS

1/2X400WATT MH/HPSV

TYPE OF LIGHT FITTING

ALUMINIUM DIA CAST

TYPE OF LAMP USED

400WATT HPSV /MH T

TYPE OF WIRE ROPE USED

6MM & 10MM, 6X37 CONSTRUCTION

TYPE OF CONTROL/FEEDER PELAR

OUT DOOR TYPE 1/3/230/440 VOLT

NO OF LIGHT CRADEL

1

NO OF PLATFOR

NIL

Sarja Products